Care And Maintenance - Pilot InstaBoost Guide D'utilisation

CARE AND MAINTENANCE

Charging Devices Using the 12V Auto Socket
1. Press button (1) 0.5 seconds to turn the jump starter/charger on.
2. Make sure the jump starter/charger has a charge. NOTE: At least 2 of
the 4 LEDs (4) should be solid-illuminated indicating a 50% charge.
3. Plug the 12V Auto Socket plug (D) into the jump starter/charger DC Output (6).
4. When charging is complete, disconnect the device from the Auto Socket (D).
5. Disconnect the Auto Socket (D) from the jump starter/charger DC Output (6).
6. Press button (1) 0.5 seconds to turn the jump starter/charger off. Or the
unit will automatically turn off after 3 minutes.
Using the Two-Setting Emergency Flashlight/Signal Flasher
1. Push and hold button (1) on the jump starter/ charger for 2 seconds.
This will activate the LED Emergency Flashlight (2).
2. Push and hold button (1) a second time for 2 seconds to activate the
Emergency Signal Flasher (2).
3. Push and hold button (1) a third time for 2 seconds to turn off the
Emergency Signal Flasher.
4. Push and hold button (1) for 3 seconds to turn off the flashlight/flasher.
Note: At any time during the operation of the LED Flashlight/Signal Flasher
sequence the unit can be turned off by depressing and holding the button
for more than 3 seconds.
1
2
4
6
D
8