Hart HAHJ01 Serie Manuel D'utilisation page 5

OPERATION
 Route the USB cable through the opening in the battery
pocket to the inside of the jacket.
 Thread the cable through the channel and opening leading
to the pocket where you wish to carry the device being
powered or charged.
 Plug the USB cable into the device you wish to power
or charge and place the device into the front left hand
exterior pocket or chest pocket to carry.
NOTE: You can route the jacket power cable through the
opening in the back of the battery pocket before connect-
CLEANING
WARNING
To reduce the risk of personal injury and damage, always
remove the battery pack and power source before clean-
ing the heated jacket. Never immerse the battery pack or
power source in liquid or allow liquid to flow inside them.
CLEANING THE HEATED JACKET
Machine wash in cold water. Do not iron.
Do not dry clean. Dry cleaning chemicals can damage the
internal wiring of the jacket.
To clean the heated jacket:
 Disconnect the jacket from the power source.
 Remove the battery pack and power source from the
battery pocket, if applicable.
NOTE: Figures (illustrations) start on page 6
after French and Spanish language sections.
ing to the power source and battery. Never allow the power
source to hang loosely by the cord.
NOTICE:
In order to avoid potential damages due to overheating,
please use the front left hand exterior pocket, inner left
pocket, or chest pocket to store devices while they are
being charged or powered.
NOTE: Do not allow the battery pack or power source
to come into contact with any liquid while cleaning the
jacket.
 Ensure power cord is contained in battery pocket before
washing.
 Machine wash the jacket on gentle cycle using cold water
and a mild liquid detergent.
NOTE: Do not use bleach, powdered detergents, harsh
liquid detergents, or fabric softener.
 Tumble dry on low heat.
NOTE: Do not wring or twist to remove water.
5 – English