Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
IV. GETTING STARTED
4.1- Unpacking
•
Remove the product from packaging
•
Check if the product and accessories (if any) are intact.
4.2- Assembly
WARNING!
Before starting assembly or changing accessories, turn it off and remove the battery
pack.
Loading staples and nails
•
Remove the battery pack from the tool.
•
Press the magazine release button (9) and pull the magazine slider (10) backward.
•
Load staples or nails into the magazine (8). See Fig. 2a and 2b for more information.
•
Push the magazine slider back in place until it clicks.
•
Reinstall the battery pack.
V. OPERATION
5.1- Intended use
This power tool is intended for indoor domestic use. This is used for fastening suitable cardboard,
insulation material, textile, leather, wood and similar non-brittle materials to wood surface. This
tool is not suitable for fastening wall or ceiling panelling. The tool is not intended for artisanal,
commercial, professional and / or industrial use.
5.2- Operation
LED work light
•
There is an LED work light (4) located above the contact switch.
•
Press the LED light switch (2) to turn on the work light, if necessary
Adjusting impact power
•
CAUTION! Select the least impact power to complete fastening.
•
Increase impact – rotate the power regulator (1) clockwise.
•
Reduce impact – rotate the power regulator (1) anti-clockwise.
Staples
Fig. 2a
Nails
Fig. 2b
Page 10 / 19
Publicité
Table des Matières
