Getting Started - Ribimex PRBAT20/PCOLSB Manuel D'instructions Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.2- Additional safety rules for electric tool
When the tool is not in use or before performing cleaning, turn it off and remove the battery
pack.
Do not leave the tool unattended while in use or directly after use.
To reduce risk of injury, keep children and bystanders away while operating this electric
tool.
Do not overreach. Keep proper footing and balance at all times.
Keep handles and grasping surfaces dry, clean and free from oil and grease.
Keep hair, loose clothing, finger and any parts of body away from ejection port, openings or
moving parts.
To reduce the risk of electric shock, do not use near water or any liquid.
Do not touch with wet hands.
Do not expose the tool to rain or wet conditions. Water entering a power tool will increase
the risk of electric shock or product failure.
Do not operate electric tools in explosive atmospheres, such as in the presence of flammable
liquids, gases or dust.
Maintain labels and rating plate through the life of service.
Do not use the electric tool if the switch does not turn on and off. Any electric tool that
cannot be controlled with the switch is dangerous and must be repaired.
Do not use an electric tool while you are tired or under the influence of drugs, alcohol or
medication.
Store idle electric tool out of the reach of children and do not allow persons unfamiliar with
the electric tool or these instructions to operate the electric tool.
3.3- Special warnings when using this product
Do not point the tool towards yourself or anyone nearby.
Ensure the working area is well ventilated. Do not inhale vapours generated while in use.
Use personal protective equipment. Always wear safety goggles and dust mask when using
the tool.
Do not use the tools in any operations that beyond the intended purpose.
Never hold the work pieces with your hand or any part of your body during operations with
the tool.
This product is designed to be powered by Ribimex 20V Li-ion battery pack only.
Use with specifically designated Li-ion battery packs (not included). Use of other batteries
may cause fire. See Table 3 for more information.
Recharge the battery pack with specifically designated Ribimex chargers (not included).
Use of other chargers may cause fire. See Table 2 for more information.
Refer to the instruction manual of Ribimex battery pack and charger for safety, quality and
operation instructions.
IV. GETTING STARTED
4.1- Unpacking
Remove the product from packaging
Check if the product and accessories (if any) are intact.
Page 9 / 19

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

620336

Table des Matières