LIMIT 1080-R Mode D'emploi page 6

Standard outfit:
Optional accessories:
Changing batteries:
Battery cover located under as showed in picture 1.
Open by pressing the lock to the centre.
1080-R/1080-G operation instructions:
1. To unlock the pendulum by sliding the button to ON position ( marked A in picture ), the laser will be
turned on. The horizontal 360º laser line is now on. Press
off the horizontal laser beam.
2. Press button (showed in picture 4) one time to turn on V1 360º vertical laser line (showed in picture 3).
3. Press button two times to turn on V2 360º vertical laser line.(showed in picture 3).
4. Press button three times to turn on V1 and V2 360º vertical laser.
5. Press button four times to turn off V1 and V2 360º vertical laser line.
6. Press button five times and it will come back to the status "2.2" in the cycle.
7. Press button (showed in picture 4) to turn on pulsation laser light. This enables to use the optional
receiver but makes the laser beam a little weaker.
8. Press button to turn off pulsation laser light. This makes the laser beam stronger.
Notice:
1. The laser unit should be put on a level surface, such as desktop, ground, tripod, etc. Self-levelling range
is ±3°, the laser lines will start flash and a buzzer will start sounding if the laser is out of self-levelling
range.
2. Make sure to lock the pendulum when not using and it is stowed away for safe keeping.
main unit, small tripod, magnetic wall bracket,
target plate, manual, batteries, protection bag.
Li-ion battery, charger, power adapter,
detector with clamp, 5/8" tripod adapter,
different tripods, laser glasses.
button (showed in picture 4) to turn on and
2
English