Cree C-LITE C-WP-A-FCT3-3L Instructions D'installation

INSTALLATION INSTRUCTIONS
PHOTOCELL OPTIONS
CAUTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety
precautions should always be followed including the
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before
installation.
DANGER – Risque de choc – Couper l'alimentation
avant l'installation.
2. This luminaire must be installed in accordance with the
NEC or your local electrical code. If you are not familiar
with these codes and requirements, consult a qualified
electrician.
Ce produit doit être installé conformément à NEC ou votre
code électrique local. Si vous n'êtes pas familier avec ces
codes et ces exigences, veuillez contacter un électricien
qualifié.
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE
LOCATING KNOCKOUT
Locating knockout in an adjustable fitter:
a. Remove wiring compartment cover from adjustable fitter
using Phillips screwdriver.
b. Using a hammer and a punch, remove knockout of wiring
compartment cover. See Figure 1.
c. See photocontrol installations.
FIGURE 1
FIGURE 1
Adjustable Fitter
following:
Knockout
Wiring Compartment
Cover
Photocontrol
http://lighting.cree.com/warranty
Document:
LPN00495X0001A1_A
Created By:
TMT
WALLPACKS WITHOUT KNOCKOUTS
1. Refer to mounting diagrams, Figure 2, for correct fixture series
and drill a 11/16" (17mm) hole in location indicated. Make sure the
photocell will fit properly before drilling.
2. See photocontrol installation
FIGURE 2
MOUNTING DIAGRAMS
C-WP-A-FCT3-3L /
C-WP-A-TRAD-3L / C-WP-A-TRAD-4L/ C-WP-A-TRAD-8L
C-WP-A-FCT3-6L/
C-WP-A-TR-12L / C-WP-A-TR-13L / C-WP-A-TR-15L/
C-WP-A-FCT3-18L
Photocell
Mounting Box
C-WP-A-TRFC-6L
Photocell
Mounting Box
PHOTOCONTROL INSTALLATION
1. Remove nut from photocell, leave o-ring.
NOTE 1: For 1000W (208-277V) fixtures remove o-ring from
photocell and replace with flat gasket provided. Discard o-ring. See
Figure 3.
NOTE 2: When installing photocontrol on C-WP-A-SL accessories,
add additional supplied nut and o-ring as shown in Figure 4.
2. Slide photocell through opening.
3. Thread nut on to threaded nipple of photocontrol and tighten to
ensure waterproof seal.
4. Wire photocontrol according to Figure 5 if wiring phase to neutral
or Figure 6 if wiring phase to phase. In all cases make sure the
photocontrol voltage is rated for the supply voltage.
5. Reinstall any parts removed during the installation of the
photocontrol.
FIGURE 3
(Flat gasket in 1000W,
208-277V xtures)
| 866.924.3645
Date:
01-24-2018
C-WP-A-TR-16L/ C-WP-A-TR-21L
Mounting Box
Photocell
*C-WP-A-SL-4L / C-WP-A-SL-8L
Photocell
Mounting Box
*See Note 2 in
Photocontrol Installation Below