Palram FERIA 3x5.4 Mode D'emploi page 86

Notes
During Assembly
Use
a
soft platform below the parts to avoid scratches and damages.
Product dimensions
can be adjusted to your specific needs:
1.The wall-mounting profile (top-back)
can be
adjusted from 260 to
305 cm
(102.4"
to
120") above ground.
The
adjusting
is
done when measuring and drilling
(Step 9).
Please
note the installation recommendations' height suggested
in
Diagram
A.
It
is
possible to fix the Patio Cover back wall height
at the lowest
point of
260
cm/102.4".
This
method
is
optional if the
assembly conditions
and
exterior walls
do
not allow to follow the suggested installation
as
appears
in
the manual.
Please note
that the product appearance may slightly change
as
a
result, however snow load weight
does
not change.
2. Poles distance from the wall
can be
adjusted from 226
to
286 cm (89"
to
112.5")
as
suggested
in
Diagram
B1.
Poles
distance from the side edges can be adjusted from
0
to
54 cm (0"
to
21.3")
as
suggested
in
Diagram
B2.
The
adjusting
is
done after assembly and before anchoring (Step 27) by sliding poles and profile 7040 +7041 at the roof
profiles' channels.
3. Wall
mounting and distance from the wall determine the roof angle and the total depth of the product
(distance of
gutter from the
wall). Higher wall
mounting
and shorter distance between wall and poles increase the roof angle and
shorten the total depth
as
suggested
in
Diagram
C.
II]
Steps
Step
7: Please
apply silicone
sealants on both sides
of the part combining 8119
in
order to prevent water leakage.
Step 8: Apply silicone
sealants on the inner part
of 8116 & 8117
and connect to the profile.
Step 16:
Please
apply silicone sealants above beam 7288
+
7290,
in
order to prevent water from seeping
in.
Step
18: Make sure
that the angle between the back wall profile and the panel supporting
profiles
is
90 degrees.
Assembly of the panels should start from the middle of the patio cover to
each side alternately.
Step 27:
Please
adjust the poles (inside out and sideways) by sliding them to their final position prior to anchoring.
Make sure
that the poles distance from the
Patio cover side edge does
not
exceed 54 cm/21.3".
*Please note: Anchoring this product to the ground
is
essential to
its
stability and rigidity.
It
is
required to complete
this stage
in
order for your warranty to be valid. (Step 28)
*Tighten
all screws
when completing
assembly.
Note:
The wall anchoring kit supplied with this product
is
suitable for concrete or solid brick walls
only.
Other wall types need
an accordant wall fixation kit.
II
260-305cm
102.4"-120"
B1
226-286cm
89"-
112.5"
0-54cm
0'-
21.3"
.
I
.
-
13°
.
+
17°
'..
,..
+
-