Troubleshooting - Honeywell RCWL300A Mode D'emploi

Installation Instructions

Troubleshooting

A 'beep' sound is heard in learn mode...
• The push you are programming has already been learned by the chime.
• If you want to change the Icon associated with the push, use the un-learn
procedure, then program the push again.
Two 'beep' sounds are heard after the normal chime sound...
• This indicates a low battery in the bell push that activated the chime. Fit a new
battery, type CR2032.
When the bell push is operated, the amber confidence light does not turn on,
or is only on for a short time...
• In normal operation, the amber light will turn on for 1 second. When the battery is
weak, the light will only turn on for a short time. Fit a new battery, type CR2032.
The chime does not work...
• Check that the batteries are the correct type, LR6 'AA' cells. Only use alkaline batteries.
• Check that the batteries are fitted correctly, with correct polarity.
• The chime could be out of range of the bell push. Try the chime in a different location.
• The chime might not have learned the identity of the bell push. Follow the
programming procedure.
69-2109EFS—05 10