First Steps; Charging The Built-In Batteries; Preparing The Receiver - Dörr AF-50 Notice D'utilisation

4 | FIRST STEPS

04.1 Charging the built-in batteries

Please fully charge the Li-Ion batteries built into the transmitter (01) and receiver (02) before using them for the first time.
04.1.1 Charging the transmitter
Insert the USB-C plug (04a) of the supplied USB charging cable (04) into the USB-C socket (01d) of the transmitter (01).
Connect the USB-A plug (04b) of the USB charging cable to a USB socket at your computer. While charging the LED charging
indicator (01e) lights up red. When the battery is fully charged, the LED charging indicator (01e) turns off. Remove the USB
cable from your computer and the transmitter. When battery is low, the LED charging indicator (01e) flashes red. Please
charge the transmitter promptly.
04.1.2 Charging the receiver
Insert the USB-C plug (04a) of the supplied USB charging cable (04) into the USB-C socket (02d) of the receiver (02). Connect
the USB-A plug (04b) of the USB charging cable to a USB socket at your computer. While charging the LED charging indicator
(02e) lights up red. When the battery is fully charged, the LED charging indicator (02e) turns off. Remove the USB cable from
your computer and the receiver. When battery is low, the LED charging indicator (02e) flashes red. Please charge the receiver
promptly.
04.2 Preparing the microphone/transmitter
1. Insert the mini jack plug (03b) on the microphone cable (03) into the microphone socket (01c) of the transmitter (01).
2. Use the tie clip (03a) to attach the microphone (03) to your tie or to the collar of your jacket, blazer, shirt or blouse.
3. Use the belt clip (01f) to attach the transmitter (01) to a discreet position, e.g. at the belt, to the waistband, to the inside pocket of
your jacket, etc. or you can simply stow it in a pocket.

04.3 Preparing the receiver

PLEASE NOTE:
04.3.1 Using with a camera, camcorder or other audio/video recording device
To use the DÖRR AF-50 wireless microphone set with a camera, camcorder or other audio/video recording device, please
use the supplied TRS spiral cable (05) with the two 3-pin 3,5 mm mini jack plugs (05a). Insert one of the two mini jack
plugs (05a) into the output socket (02c) of the receiver (02). Plug the other mini jack plug (05a) into the microphone socket
of your camera or recording device.
If your camera or recording device is equipped with a hot shoe
mount, the belt clip (02f) can be used as a hot shoe and the receiver
(02) can be mounted onto your camera.
11
To ensure correct function, always use the two supplied cables as described below.
doerr-foto.de