Roadstar CD-825U/HP Manuel D'instructions page 8

If any of the ID3-TAG information is not available, pressing the BAND button re
peatedly will show information in the following sequence:
UNKNOWN SONGNAME> UNKNOWN ARTIST> NO ALBUM TITLE > UNKNOWN
YEAR > NO COMMENTS
If the MP3 file is without ID3 TAG, pressing the BAND button, "NO ID3 TAG" will be
displayed.
The file name & track number of the MP3 file will scroll repeatedly through the display
during the playing of the MP3 file.
HOW TO SELECT MP3 FILES
A. Searching Track directly
Keep pressed the BAND Button (10) once, the displays shows "TRK SCH": select the
MP3 track by rotate the Volume knob (3) to scroll through the numbers. Then press
ENTER (VOLUME) to confirm.
B. Searching by Directory or FIle name
Keep pressed the BAND twice, the displays shows "FILE SCH". Enter the character
directly. The unit searches files and directories which have the same character which is
inputted by the user. The unit shows these sorted files and directories by VOLUME UP /
DOWN (1) Knob. If the selected name is directory, the user can go into the selected
directory by press MP3 ENTER BUTTON and continue to search the directory or file
name in the directory by VOLUME UP / DOWN knob. The selected file can be played by
pressing MP3 Enter Button.
Rotate the Volume knob (3) in both directions to scroll through the characters
(alphanumerical). Then press ENTER (VOLUME) to confirm.
C. Searching from Directory
SEARCH DIRECTORY BY USING VOLUME UP / DOWN KNOB.
Under MP3 play mode, keep pressed BAND three times. Then the first Directory name
is shown (DIR SCH). Move VOLUME UP/DOWN to navigate through the directory list,
press MP3 ENTER BUTTON to select the desired directory. Select the tracks under the
selected directory, press MP3 ENTER KNOB knob again to confirm when desired track
is found. Rotate the Volume knob (1) in both directions to scroll through the characters
(alphanumerical). Then press MP3 ENTER BUTTON (3) to confirm.
English 11 12 English
SPECIFICATIONS
CD/MP3 PLAYER SECTION
Signal to Noise Ratio > 70dB
Channel Separation > 50 dB (1kHz)
Frequency Response 20Hz - 20 kHz
TUNER
Sensitivity 2 dBμ
Stereo separation 35 dB
Signal to noise radio 55 dB
FM Frequency range 87.5-108 MHz
MW Frequency Range: 522 - 1620 KHz
Channel step FM: 50 kHz
Channel step MW: 9 kHz
Intermediate frequency 10.7 MHz
LINE-OUT
Output 350mV max.
Impedance 10kOhm
GENERAL
Power Supply 13.8V DC
(10.8-15.6V allowable)
Speaker impedance 4 or 8 ohm
Output power 25 W (RMS) x 4CH, 4 x 45 W M. Power
Note: Specifications and the design are subject to possible modification without notice due
to improvement.
Correct Disposal of This Product (Waste Electrical & Electronic
Equipment)
This marking shown on the product or its literature, indicates that it should
not be disposed with other household wastes at the end of its working
life. To prevent possible harm to the environment or human health from
uncontrolled waste disposal, please separate this from other types of
wastes and recycle it responsibly to promote the sustainable reuse of
material resources.
Household users should contact either the retailer where they purchased
this product, or their local government office, for details of where and how
they can take this item for environmentally safe recycling. Business users
should contact their supplier and check the terms and conditions of the
purchase contract. This product should not be mixed with other
commercial wastes for disposal.