Romus STEAM MASTER Mode D'emploi page 20

Decolleuse papier peints
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

You must never allow the unit to boil dry. There is a safety thermal cut-out device
fitted to the unit. If the unit is allowed to boil dry this will operate and prevent further
use.
• Switch the unit off and allow it to cool for at least 5 minutes, refill with water and then switch on
again - the thermal cut-out should automatically reset.
• If this has not reset allow a further cooling period.
• When you have finished using the unit allow any remaining water to cool and then empty the
unit. We recommend flushing the tank out with clean water before storing.
Never leave water in the unit whilst being stored.
Storage Spools
• The supply cord and hose must be fully unwound before commencing to operate the unit.
• To recoil the supply cord, fit the plug into the socket-outlet on the side of the spool and then wind
the supply cord onto the spool.
• To recoil the hose, place the steamplate end of the hose into the side aperture of the spool and
then wind the hose onto the spool (Fig. 1, E).
Storage Steamplate
• The handle of the steamplate is shaped to locate between the frame and
the tank.
• Slide the steamplate into position with the handle against the tank and the thread towards the
base (Fig. 1, F).
Model
LMB 230 V
LMB 110 V
*Approx. steam time before the safety cut-out operates.
STORAGE
Boiler Capacity
7,5 L
7,5 L
20
STEAM MASTER| Réf. 194550
Steam Time
80-100 minutes*
195 minutes*
GB

Publicité

Table des Matières
loading

Produits Connexes pour Romus STEAM MASTER

Ce manuel est également adapté pour:

194550

Table des Matières