Troubleshooting - Remington RM191BV Guide Du Propriétaire

12 |
6

troubleshooting

WARNING: Unplug blower/vac from power source before servicing. Severe
injury or death could occur from fire, electrical shock, or rotating impeller.
Note: For additional help, visit
www.remingtonpowertools.com.
OBSERVED FAULT
Motor does not run when you turn on/off
switch low or high
Motor runs, but vacuum will not pick
up debris
Blower/vac vibrates excessively and/or
makes abnormal noises
POSSIBLE CAUSE
1. Bottom inlet cover or vacuum tube
adapter not locked into place
2. Extension cord connection is loose
1. Clogged vacuum tube or impeller
2. Vacuum bag full
Clogged vacuum tube or impeller
REMEDY
1. Check inlet cover or vacuum tube
adapter for proper installation (see
blower/vac assembly, page 4)
2. Check cord connection at electrical
outlet and at rear of blower/vac
1. Follow steps under Removing
Clogged Debris from the Impeller,
page 10
2. Empty vacuum bag (see Emptying
the Vacuum Bag, page 10
Follow steps under Removing Clogged
Debris from the Impeller, page 10