Time Settings; Firmware Update; Factory Settings - Hama 00062789 Manuel D'installation Et D'utilisation

4.4 Time settings

This section describes how to set the time settings on your Wireless Internet Radio. The time is shown in the display
when the device is off. In addition, your Wireless Internet Radio also has an alarm function, which can also be set
through this menu item.
Use the rotary controller to set the time in these menu items. Confirm your selection by pressing „Select".

4.5 Firmware update

Due to constant further development and improvement of operating software, it is necessary to regularly update the
device software (firmware update). To check whether an update is available, take the following steps:
Go to „Configuration" from the main menu.

4.6 Factory settings

This menu item will reset your Wireless Internet Radio back to the factory settings.
Note: All of the settings you have made will be lost.
20
Select the „Configuration" menu item from the main menu.
You will get to the menu item "clock" by using the navigation buttons
(Tune +,- ; Volt +,-)
Select „Set Time" to set the time, or „Set Alarm" to activate
the alarm function.
Then select „FirmwareUpdate". If an update is available, it is
automatically installed. If there is no update available, the Internet Radio
will automatically switch back to the Configuration menu.