YUNEEC E50 Guide De Démarrage Rapide page 8

Binding the E50
Step 1.
Switch on the ST16S followed by the H520 aircraft.
Step 2.
Tap the [ ] on the top right corner of the main
interface of ST16S.
Step 3.
Tap the serial number of the E50 when the following
window pops up. (If multiple Yuneec UAS are used,
check the ID number on the side of each camera to
assure correct camera selection/binding).
Step 4.
Using the password "1234567890", authorize the
camera and tap "OK" to confirm.
NOTICE
If the connection process is delayed, close the pop
up window and then repeat the above steps.
Fly
Takeoff
RTL
Pause
Action
Fly
Select Vehicle to Connect
Takeoff
RTL
E50
Pause
Action
Reset All Links
Fly
Please enter password for
Takeoff
RTL
E50
Pause
Action
Reset All Links
Not Connected
75%
Not Connected
75%
31009B
Close
Not Connected
75%
E50 31009B
ok Cancel
31009B
Close
N/A
NO CAMERA
N/A
NO CAMERA
N/A
NO CAMERA