Nivian ONV510 Manuel D'installation page 5

ONE KEY WPS/QSS WIFI CONFIGURATION
1. Power up the camera using the included PSU. After a
few seconds a blue status LED will light and the camera
will beep to indicate that it is in configuration mode. Then
press & hold the reset button for between 3 & 5 seconds
then release.
2. Press the WPS/QSS button on the Router. The two
devices will then link.
3. Once configured the camera status LED will flash quickly
for a brief time and then become steady indicating that the
link to the Router has been successfully made.
Please note: This option is will only work correctly if the
Router supports the WPS/QSS.
For more information visit: www.nivianhome.com
FR
Manuel d`installation
Caméra IP Nivian ONV510
Bouton Reset & WPS/QSS
LED d´état
Entrée DC5V
Micro
Capteur d´illumination
Objectif
Leds IR infrarouges