Table des Matières
Publicité
1. Attach the scope to the tripod.
2. Turn the clamp adjustment knob (A) on the adapter counter clockwise and make sure there is sufficient
space for the adjustable eyepiece clamp (B) of the eyepiece on the scope.
3. Insert the eyepiece into the eyepiece clamp (B) and turn the clamp adjusting knob clockwise until it is
secured.
4. Focus the scope on the subject before attaching the camera to the camera platform (C).
5. Loosen the camera mount screw (E) and move it as far as possible from the scope.
6. Turn on your camera and allow the zoom to fully extend before attaching it to the camera platform (C)
by using the camera mount screw (E).
7. Use the camera mount screw (E) and the platform height adjustment screw (D) to align the lens on the
camera with the eyepiece of the scope. The camera's lens has to be as close as possible to the scope's
eyepiece, and the image must be visible on the camera's LCD screen or through the camera's view
finder. The additional height adjustment (G) may be used if required. It may be necessary to refocus
your camera (see your camera's instruction manual) to ensure that the AF system is locked onto the
subject through the scope. Readjusting the position of the camera or the focus point of the scope may
be required.
8. Some vignetting might occur. This can be reduced by zooming in on the subject via the camera. Ensure
there is sufficient tolerance between the camera's lens and the eyepiece of the scope. Refocusing of
the scope may be required.
Warranty
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
Disclaimer
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of their respective holders
and are hereby recognised as such. Keep this manual and packaging for future reference.
DE-Deutsch
Einleitung
Wichtiger Hinweis:
• Vor dem Anschluss des Digiscope-Adapters und der Kamera an das Okular des Spektivs achten Sie
darauf, dass das Okular und Spektiv sicher befestigt und imstande sind, ein solches Gewicht zu tragen.
• Beim Anbringen der Kamera an den Adapter ist auf ausreichenden Freiraum zur Erweiterung des
Kamerazooms zu achten, ohne dass das Okular jegliche Behinderung verursacht.
©2012 NEDIS BV. Camlink is a registered trademark of NEDIS BV. Although every effort has been
made to ensure the accuracy of the information contained in this manual specifications are subject to
change and therefore NEDIS BV cannot guarantee its correctness and completeness at all times.
Empfohlen
Nicht empfohlen
4
Publicité
Table des Matières
