Cleaning And Maintenance - Di4 Aria Silence 30 Mode D'emploi

ASSEMBLY
Warning: the fan may only be used if it is fully and correctly assembled, i.e. with the base and pro-
tection grille.
Warning: always disconnect the appliance from the mains supply before assembling.
If in doubt, have a qualified, professional technician check the appliance or assemble it. To assemble
the fan, use the following figures in the diagram as a reference. To assemble the fan, use the following
diagrams as a reference.
1. Insert the lower part of the body into the base (8) (see diagram on the right), so
that the 3 clips fit into their corresponding slots. Warning: the fan cannot be used
without the base.
2. Place the rear grille (4) onto the body, make sure that the handle appears at the
back (as shown by the arrow) and secure it in place with the mounting nut (3).
3. Insert the fan blade (10) onto the motor shaft (5) and secure it with the blade
mounting ring (2) screwing it in place in an anti-clockwise direction.
4. Connect the front grille (1) to the rear grille (4) by tightening the screw (11). Once done, check that
the protection grilles are joined together tightly and attached to the motor.
USE
Before each use, check that the appliance is in good condition and that the power cord is not dam-
aged: If the power cord is damaged, request that it be changed by the manufacturer's technical sup-
port service or a person with a similar qualification, in order to avoid any danger.
Plug the appliance into the mains socket.
Ventilation: select the desired speed using the corresponding buttons (9):
1 - Minimum speed 2 - Medium speed 3 - Maximum speed
To turn the fan off, press button "0" and then disconnect the appliance from the mains socket.
Horizontal oscillation(right-left): press the knob (6) located on the body of the motor downwards.
To stop the movement and so the fan is stationary, pull the knob upwards.
Vertical tilt (up-down): this is adjusted by holding the body of the motor and tilting it in the desired
direction.
In case of long periods of inactivity, disconnect the plug from the mains socket.

CLEANING AND MAINTENANCE

Warning: before carrying out regular cleaning operations, disconnect the plug from the mains socket.
• To clean the appliance, use a soft, slightly damp cloth; do not use abrasive or corrosive products.
• Do not immerse any part of the fan in water or any other liquid: if this should happen, under no
circumstances should hands be put into the liquid; first disconnect the plug from the mains socket.
Then dry the appliance carefully and check that all the electrical parts are dry: if in doubt, check with
professional qualified technician.
• It is essential that the motor ventilation holes are free of dust and fibres.
• In case of long periods of non-use store the fan, protecting it from dust and moisture; we recom-
mend using the original packaging.
13