Table des Matières
Publicité
SPECIFICATIONS
120 Volts
7.0A
220 Volts
3.5A
INTRODUCTION
Thank you for purchasing the Alpha
225 Electric Wet/Dry Stone Cutter. Please read this
instruction manual thoroughly to ensure safe and
correct use of the electric wet/dry stone cutter. Keep
this manual in a place where operators can access it
easily whenever necessary.
ABOUT THE SYMBOLS
According to the hazard level, all safety notes in this
manual are classified into "DANGER", "WARNING"
and "CAUTION".
DANGER! - Death or serious personal injury is
imminent when handling this electric wet/dry stone
cutter incorrectly.
WARNING! - There is a possibility of death or serious
personal injury when handling this electric wet/dry stone
cutter incorrectly.
CAUTION! - There is a possibility of personal injury
or property damage when handling this electric wet/dry
stone cutter incorrectly.
NOTE: In some situations, failure to observe
WARNING notes could result in death or serious
personal injury. Be sure to read and observe the
safety notes to ensure safety and correct use of the
electric wet/dry stone cutter
SAFETY INSTRUCTIONS FOR POWER
TOOLS
1. Know Your Power Tool. Read owner's manual
carefully. Learn its applications and limitations
as well as specific potential hazards particular to
this tool.
2. Keep Work Area Clean. Cluttered areas and
benches invite accidents.
3. Avoid Dangerous Environments. Keep
work areas as dry as possible. Do not use tool in
presence of flammable liquids or gases. Keep the
area well lit.
12,000
1200W
RPM
ESC-125/ESC-
®
.
A(120V)
8.9 lbs
C(230V)
4.0 kgs
4. Keep Children and Visitors Away. All
visitors should be kept a safe distance from the work
area. Keep out of reach of children.
5. Don't Force Tool. It will do the job better and
safer at the rate for which it was designed.
6. Wear Proper Apparel. Do not wear loose
clothing or jewelry as it can get caught in moving
parts. Rubber gloves and insulated non-skid
footwear are recommended. Wear protective
covering to contain long hair.
7. Wear Proper Eye Protection. All users and
bystanders must always wear proper personal eye
protection which conform with ANSI/ISEA Z87.1
(CAN/CSA Z94.3). Also, use a face or dust mask
if operation is dusty. Always wear certified safety
equipment.
8. Wear Proper Ear Protection. All users and
bystanders must wear proper personal ear protection
which conforms with ANSI S12.6 (S3.19) hearing
protection.
9. Wear Proper Respiratory Protection. All
users and bystanders must wear proper personal
respiratory protection. Always use NIOSH/OSHA
approved respiratory protection appropriate for the
dust exposure.
WARNING! Some dust created by power
sanding, sawing, grinding, drilling, polishing and
other construction activities contains chemicals
known to the State of California to cause cancer,
birth defects, or other reproductive harm.
Some examples of these chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks, cement and other
masonry products, and
• Arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies,
depending on how often you do this type of
work. To reduce your exposure, work in a well
5"
1-5/8"
(ESC-125)
125mm
41mm
7/8"
22.23mm
(ESC-225)
English
3
Publicité
Table des Matières
