Taurus CUTMASTER COMPACT Manuel page 9

FINISHED USING THE APPLIANCE:
- Stop the appliance by releasing the pressure
on the buttons.
- Unplug the appliance from the mains.
- Clean the appliance.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- During the cleaning process, take special care
with the blades, as they are very sharp.
- It is advisable to clean the appliance regularly
and remove any food remains.
- If the appliance is not in good condition of
cleanliness, its surface may degrade and
inexorably affect the duration of the appliance's
useful life and could become unsafe to use.
- Neither parts of this appliance are suitable for
cleaning in the dishwasher.
- The following pieces may be washed in hot
soapy water:
- Shield – pusher.
- Foldable platform.
- To remove the platform, fold the platform and
extract by pulling the bottom left-hand.
- The cutting guide can be removed to clean by
turning the regulator counterclockwise.
- The blade, sliding carriage and body can be
cleaned with a slightly moistened cloth.
- Then dry all parts before its assembly and
storage.
- To place the platform, first fit on the right side
and then press on the left side.
- From time to time it is convenient to remove the
blade for a more through cleaning. To do so,
turn the axle of the blade to the right about 90º
and take it out with care.
- With a soft sponge or cloth, clean both sides of
the blade with soap and water. Rinse and dry
the blade.
- To replace the blade, place it back into position,
hold the tab and align the blade with the trans-
mission gears until it fits snugly. Turn tab in the
opposite direction to tighten the blade.