PMA Ex-System Mode D'emploi Et Instructions De Montage page 2

A
1
A. Conduit
B. Ex Seal cap (yellow)
A
2
Cut the conduit straight in the corrugation (A).
3
Push seal cap (B) com pletely onto conduit in order to achieve IP68.
The specifications and instructions for our customers in this document reflect
the product engineering level at the time of manufacturing. Please consider
the valid data sheet release at a time. For questions please contact the PMA
customer service. PMA AG accepts no liability for damages resulting from
unprofessional installation or application or misuse for a purpose. This dis­
claimer also includes damages to third parties. It is the cus tomer's responsibi­
lity to check the delivered products and immediately notify PMA AG of detec­
ted faults. It is also the customer's res ponsibility to test the delivered product
PMA AG (Headquarters) · Aathalstrasse 90 · 8610 Uster · Switzerland · Tel: +41 44 905 61 11 · Fax +41 44 905 61 22 · pma-ch.info@tnb.com · www.pma.ch
C
B
D
C. Fitting
D. Oval clip
B
4
Screw fitting (C) onto thread. (See safety remarks)
A+B
5
Push conduit with sealing cap (A+B) into the fitting until sealing cap is no
more visible in the locking element window.
D
6
Insert Oval clip (D) in the locking element window and click into place.
The screwdriver slot in the oval clip should be on the conduit side.
To re­open use a screwdriver.
on its applicability for the intended purpose. PMA AG will accept no liability or
responsibility for their products if a product or a PMA system is combined or
used together with third­party products, i.e. products from other companies
than PMA AG. Jurisdiction in all legal disputes concerning product liability
have the courts of the canton of Zurich/Switzerland. Swiss law applies.
For more information and the latest data sheet releases go to: www.pma.ch
C