Operating Your Compressor Nebulizer - Medquip MQ6000 Manuel D'instructions

Operating Cautions:
1. Connect this product to an appropriate voltage outlet for your model.
2. Do not run this product unattended.
3. Never operate if this unit has a damaged cord or plug, if it has been dropped,
or in any way, into water, if it does not work properly. Return it to a service
center for repair.
4. If any abnormality occurs, discontinue use immediately until the unit has
been examined and repaired.
5. Always unplug the product immediately after use.
6. Never block the air openings of the main unit or place it where the air
openings may be obstructed.
Storage Cautions:
1. Do not store the unit under direct sunlight, high temperature or humidity.
2. Keep the unit out of reach of small children.
3. Always keep the unit unplugged while not in use.
Cleaning Cautions:
1. Do not immerse the unit in water. It may damage the unit.
2. Disconnect the unit from the electrical outlet before cleaning.
3. Clean all necessary parts after each use as instructed in this guidebook.
Save These Instructions

4. OPERATING YOUR COMPRESSOR NEBULIZER

Note: Prior to initial operation, the nebulizer should be thoroughly cleaned.
1. Place your Compressor Nebulizer on a flat and stable surface. Be sure that
you can easily reach the controls when you are seated.
2. Open the Top cover.
Important: Prior to initial operation, the nebulizer should be thoroughly
cleaned referring to the "Cleaning Procedures" in the manual.
3. Gently twist the top part of the nebulizer counter-clockwise to disassemble
the nebulizer.
4. Fill the bottom section of the nebulizer
with the medication prescribed by your
physician. Be sure that the cone is put
inside the bottom section.
5. Gently twist the top part clockwise to
reassemble the nebulizer. Be sure the
two sections fit well.
4
Place cone inside
and fill medication