Guardian Technologies PUREGUARDIAN H7500 Utilisation Et Instructions D'entretien page 5

DIRECTIONS FOR USE
CONTROL OPERATION
WARM MIST
1. Warm Mist Control
Selects warm mist. Water temperature
is maintained at room temperature for
cool setting and 80 degrees for warm.
Allow 15 minutes for water to warm.
LIGHT
3. Night Light Control
Press the Night Light button to
illuminate the night light.
E-8
8
4 12
2. Timer
Press the Timer button to select either
4, 8, or 12 hours. The unit will turn off
in that time.
M
L H
4. Mist Control Button
When you press the Mist Control
button there are three options:
Press once for LOW
Press twice for MEDIUM*
Press three times for HIGH
*Medium is default setting
CLEANING
CLEANING
• Always unplug the unit before servicing in any way.
• The water temperature of the water remaining in the unit after use may be high, allow
time for it to cool.
GENERAL CLEANING
• Inside the base of the unit. Pour excess water out of the unit. Wash out the unit with fresh
water using the cleaning brush and a soft cloth as needed. Do not submerse the base of the
unit into water, or allow water to enter inside the dry air exhaust port of the unit.
• Water tank. Empty water tank. Remove mist nozzle and clean the mist tube with fresh water
and a light brush (bottle cleaning brush is recommended).
• Outer surface of the unit. Wipe the surface of the unit with a soft, damp cloth if needed. If
you notice an accumulation of water during usage, reduce humidity and dry outer surface with
a cloth.
DESCALING
• Depending on usage and water type, cleaning to remove scale may be required
weekly or every other week to optimize unit performance.
• If you live in a hardwater area, we recommend the use of distilled water for your
humidifier. This will help reduce the precipitation of minerals or 'white dust'.
• Do not clean the unit or water tank with detergents or cleaning chemicals of any kind.
ULTRASONIC DISK
1. Unplug unit.
2. Remove the tank and empty all water from unit base and tank.
3. Locate the ultrasonic disk on the inside center of the base unit. (see pg. E-4)
4. Use ONLY the enclosed cleaning brush to gently clean disk and remove build up and deposits
(Figure 1). Do not scrub or scrape the ultrasonic disk.
Figure 1
*Clean the disk with the
brush only. No other
cleaning tool should
be used. BRUSH ONLY.
(Figure 1)
Ultrasonic Disk
E-9