Saneo JHS-A19-07KR2/E Mode D'emploi page 46

TROUBLESHOOTING
Problem Possible reasons
There is no electricity.
The 'water tank full' indicator is on.
The room temperature is too low or too
high.
The air
In cooling mode, the room temperature
conditioner does
is lower than the set temperature; in
not work.
heating mode, the room temperature is
higher than the set temperature.
In dehumidifying mode, the temperature
is too low.
The room is in direct sunlight.
The doors and windows are open or
The room is not there are heat sources in the room.
cool enough. The filter is dirty.
The air inlets and outlets are clogged.
The air
conditioner emits The air conditioner is not on a flat
an unpleasant surface.
noise.
Solutions
Plug the air conditioner into the mains supply.
Empty the water tank.
The air conditioner must be used in a room with
a temperature between 7°C and 35°C.
Reset the temperature.
The appliance should be placed in a room with a
temperature of more than 17°C.
Close the curtains.
Close the doors and windows and remove the
heat sources.
Clean or replace the filter.
Unclog the air inlets and outlets.
Place the air conditioner on a flat and stable
surface to reduce the unpleasant noise.