Fanaway ORBIT DC Guide D'installation page 7

Fanaway Orbit Installation Instructions
HANGING THE FAN ASSEMBLY
•
Lift the fan assembly（1）up to the mounting bracket. Hang the fan assembly onto the J-hook (2) of the
mounting bracket. (Fig.3)
•
Complete the electrical wiring according to the 'ELECTRICAL WIRING DIAGRAM' section below.
PREPARE AND COMPLETE THE ELECTRICAL WIRING --- WIRING DIAGRAM (FIG. 4)
NOTE: AN ADDITIONAL ALL POLE DISCONNECTION SWITCH MUST BE INCLUDED IN THE FIXED
WIRING.
NOTE: IF THERE ARE TWO OR MORE DC CEILING FANS INSTALLED IN THE ONE LOCATION, AN
ISOLATION SWITCH IS REQUIRED FOR EACH CEILING FAN. THIS IS REQUIRED WHEN
PROGRAMMING THE REMOTE AND RECEIVER TO PAIR TOGETHER.
From mains supply to mounting bracket terminal block: (Fig. 4)
1. Connect the live supply wire to the "L" terminal of the terminal block on the mounting bracket.
2. Connect the neutral supply wire to "N" terminal of the terminal block on the mounting bracket.
3. Connect earth wire to the earth terminal of the terminal block on the mounting bracket.
From mounting bracket to receiver and motor: (Fig. 4)
4. Connect the supply wiring connector from the mounting bracket to the input of the DC remote receiver.
5. Connect the output wires of DC remote receiver (from mounting bracket with earth wire ) to the output of
the DC remote receiver (Fig. 4). Connect the output wires of DC remote receiver with earth wire (from
mounting bracket with earth wire ) to the input of the fan motor (Fig. 4)
6. Connect the output wires of DC remote receiver to the input wires of the fan light kit.
7 | P a g e
（2）
（1）
Fig. 3