Fanaway ORBIT DC Guide D'installation page 13

Fanaway Orbit Installation Instructions
•
There will be a notification 'beep' sound from the receiver to indicate that the paring process is
successful.
•
Turn ON the fan and change the speed of ceiling fan 2 by the remote to check the operation and
successful pairing.
If pairing has been unsuccessful, repeat these set of steps again.
REMOTE CONTROL (Fig. 9)
The LED light has a 3-step dimmable function which is controlled by remote Light ON/OFF button.
When the LED light is ON and at 100% brightness, press the light button "ON and then OFF within 5
seconds", to dim the LED light. Repeat pressing Light button ON and then OFF within 5 seconds to dim
further in the following sequence: 100% brightness → 60% brightness → 10% brightness → 100%
brightness.
To switch back to 100% brightness at any stage, turn OFF the luminaire, and then wait after 5 seconds turn
ON the luminaire, it will reset to 100% brightness.
REPAIRING THE REMOTE & RECEIVER PAIRING – WHEN 1 CEILING FAN IS INSTALLED
•
If the remote and receiver lose control after installation or during use, the pairing of the remote and the
receiver must be repaired.
•
Below are the operating symptoms and the steps to repair the pairing of the remote and receiver.
13 | P a g e
(1) Reverse control
(2) Natural wind (The fan speed automatic cycle
between 1 to 6 speed)
(3) Speed control
(4) Light On/Off
(5) Fan On/Off
(6) 1.5V AAA battery x 2 pcs (Included)
Fig. 9