Ice Making - Samsung RF28DED Serie Mode D'emploi

Masquer les pouces Voir aussi pour RF28DED Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Ice Making

To fill the ice bucket to maximum capacity after
installation, follow these steps:
1. Allow your refrigerator to operate and check
Ice maker button, if ice maker off is illuminated,
turns on the ice maker. Then "Ice maker Off"
will be dissaper and wait 24 hours (or 1 full
day).
- Waiting 24 hours will allow your ice maker to
cool properly.
2. Dispense 4 to 6 ice cubes into a glass.
3. After 8, and then 16 hours, dispense a full glass
of ice.
CAUTION
• To clean the ice bin/bucket, wash with a mild
detergent, rinse well, and then dry it thoroughly.
Do not use harsh or abrasive cleaners or
solvents.
• When you select Cubed Ice after using the
Crushed Ice mode, a small amount of residual
crushed ice might be produced.
If There is a Power Failure
If a power failure occurs, ice cubes may melt,
and then freeze together when the power comes
back on, preventing the dispenser from working
properly.
To prevent this problem, after a power failure, pull
out the ice bucket and discard the residual ice or
water.
After you dump the ice from the ice bucket, you
should press the dispenser lever once with the
'Water' or 'Ice Type' function ON.
The ice maker will make new ice faster after you
return the ice bucket to the refrigerator.
DA68-03029A-10.indb 26
If you use all the ice at once, you must
repeat Steps 2 and 3 under Ice Making.
However, only wait 8 hours before
dispensing the first 4 to 6 ice cubes.
This will replenish the ice cubes and
ensure maximum ice production.
Using the ice off Function
When you select the Ice Off mode, remove all ice
cubes from the bucket.
If you leave the ice cubes in the bucket, the ice
cubes may clump together, making it difficult to
remove them.
To remove the ice bucket safely and avoid injury,
hold the bottom of the bucket with one hand and
the side of the bucket with the other.
Then, lift up on the ice bucket, and pull it straight
out.
To put the ice bucket back in, push it firmly straight
back.
If the ice bucket is not pushed firmly into
place, ice in the bucket can melt.
If the bucket does not fit, turn the helix 90 degree
(see the last illustration on the right, below) and try
again.
CAUTION
• The inside of the ice bucket is very cold when
the refrigerator is operating.
Do not reach deep inside the ice bucket.
• Use only the ice maker provided with the
refrigerator.
• Have the refrigerator's water supply connected
only to a potable water supply.
• To operate the ice maker properly, water
pressure of 20 ~ 125 psi is required.
English - 26
2018. 5. 17.
10:41

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rf28hdedbsr/aaRf28hdedpww/aa

Table des Matières