Floor Cleaning; Spare Parts - Kärcher FR 30 Mode D'emploi

Assemble nozzle packet
Figure 2, see cover page
1 O ring
2 Rotation arm
3 Nozzle
4 Union joint
 Inser the O ring in the nut of the rotation
arm.
 Place the nozzle on it.
 Slightly fasten the nozzle with the Union
joint.
Note:
The exit jet must be directed parallel to the
rotation arm.
Figure 3, see cover page
 Adjust the wrench area of the nozzle
(width 10) so that it is parallel to the ro-
tation arm.
 Tighten the Union joint (width 22) using
a wrench.

Floor cleaning

Figure 4, see cover page
 Connect the steel pipe of the high pres-
sure cleaner to the FR 30 and tighten it
with wrenches (width 24).
 During breaks in working, tilt the hand
spray gun with spray pipe towards the
front. The appliance is then in its park-
ing position.
6
Wall cleaning
Figure 5, see cover page
1 Connectiing piece
2 Screw
 Place the connecting piece vertically.
 Turn in the enclosed screw in order to
hold the joint firmly.
Figure 6, see cover page
1 Enclosed adapter
2 Hand spray gun
 Screw the adapter to the connection
and tighten it with a wrench (key width
22).
 Screw the hand spray gun on the adapt-
er, align it and tighten it with a wrench
(key width 27).
Figure 7, see cover page
 Hold the appliance at the handle while
cleaning the wall.
 Protect the appliance against frost.
 Do not allow bristles to deform during
storage.
Only use original accessories and spare
parts, they ensure the safe and trouble-free
operation of the device.
For information about accessories and
spare parts, please visit www.kaerch-
er.com.
– 2
EN
Care

Spare parts