Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Assembly
Wall Mounting
The product can be wall mounted, if desired,
using the wall mount bracket, screws and
anchors supplied. To wall mount the vac, refer
to figures B, C, D and E.
• figure B - Mark the location of the screw
holes (within reach of an electrical outlet
for chargeing the vac while it is on the wall
bracket).
• figure C - Insert the charger cord into the
curved slot in the wall mount bracket leaving
approximately 8-9 inches (203mm - 227mm)
excess as shown.
• figure D - Hang the vac on the wall by placing the opening on the
base of the vac over the hooks in the wall mount bracket as shown in
figure D.
• figure E - Insert the jack plug into the
charging socket.
Charging the battery
From new, the rechargeable cells of the product
need a minimum charge time of 9 hours to ensure
full power.
We suggest you fully discharge the product when
it is used for the first time as this will help the cells
recharge faster.
• The switch must be in the off ("O") position, the
product will not charge if it is in any other position.
• figure f - Plug the jack plug of the charger into
the charging socket of the tool. Plug the charger
into any standard 120 Volt 60 Hz electrical outlet.
The charging indicator will be lit.
While charging, the charger may get warm, this is
perfectly normal and safe. It is safe to leave the
appliance connected to the charger indefinitely.
The charger automatically reduces power
consumption when charging is complete.
• When charging is complete, the LED will turn off.
WARNING:
below 39°F (4°C) or above 104°F (40°C).
Do not charge the battery at ambient temperatures
4
B
E
F
C
D
Publicité
Table des Matières
