Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. Remove screws from Rear Guard and tilt wheel
(figure 2).
2. Loosen motor nuts, and motor safeguards (located
above and below motor).
figure 2: Removing Guard
1. Inspect your fan before each use. Check all wires and
extension cords, following the procedure outlined on
Page 2 (Safety Information).
figure 4: Capacitor Assembly
© 2015, Pinnacle Products International, Inc.
Belt Tightening / Replacement
Maintenance and Storage
4
3. Remove belt to replace, or adjust motor to tighten belt
(figure 3).
figure 3: Adjusting Fan Belt
2. After use, always be sure fan's Power Switch is in the
OFF position before unplugging. Use cord wrap (see
page 6 Item #7) to keep cord off the ground when
transporting fan.
Bearings
figure 5: Fan Shaft Assembly
Portable Air Circulator User's Manual
NEVER LEAVE A FAN
UNATTENDED WHILE
OPERATING OR WHILE
CONNECTED TO A POWER
SOURCE
Bearing E-clips
Publicité
Chapitres
Table des Matières
Dépannage
