Chauvet Professional Cloud 9 Manuel De Référence page 5

Programming
Refer to the Menu Map to understand the menu options. The menu map shows the main level and a variable number of
programming levels for each option.
• To go to the desired main level, press <FUNCTION> repeatedly until the option shows on the display. This will take
you to the first programming level for that option.
• To select an option or value within the current programming level, press <UP> or <DOWN> until the option shows
on the display. If there is another programming level, you will see that first option, or you will see the selected value.
• Press <FUNCTION> repeatedly to exit to the previous main level.
Operation
1. Place the machine on a level surface. Plug the power cord into the wall.
2. Remove the top lid.
3. Fill the water tank with distilled water to the maximum fill line located on the inside of the tank. The container can
hold up to 5.3 gal or (20 l).
4. Fill the fluid tank with CHAUVET haze or fog fluid to the maximum fill line located on the outside of the tank. The
container can hold up to 1 gal (3.5 l).
5. Turn the product on using the power switch on the back panel. Make sure the fans are operating properly.
6. Using the control panel, set the product to the desired operating mode.
• Due to water evaporation, you may need to refill the Cloud 9 with water to continue triggering
the machine.
• The Cloud 9 is fitted with a safety shutoff feature, which prevents the unit's heaters from
turning on when the water level is too low. If this safety shutoff feature has been engaged,
simply add more water to continue using the Cloud 9.
The Cloud 9 can operate with the top lid on or off.
Operation Continued
To prepare the Cloud 9 for operation:
1. Open the flight case.
2. Pull out the fluid tank and remove the cap.
3. Verify that the two plastic hoses attached to the inside of the cap are in place and in good condition.
4. Pour Chauvet fog fluid inside the tank, and re-cap.
5. Reinsert the tank.
6. Make sure that the plastic hose that goes from the cap to the fogger is not bent.
7. Plug in power and wait approximately 4 minutes for warm-up to complete.
When storing the product, ALWAYS be sure to store the fluid tank with the cap up as seen on the
Floor Mounting Diagram above before installing the front cover to avoid tube damage that may
cause leakage.
Only use Chauvet approved fog fluid. Otherwise, you might not have satisfactory results. In
addition, unapproved fluid can damage the Cloud 9 or cause harm to humans or animals.
FCQ (Fog Cleaner Quart) was specifically developed by Chauvet to clean your Cloud 9. Make sure
you use FCQ regularly, no longer than 90 days between cleanings, to increase the life of your
product.
Condensation may form on the bottom of the product, creating damp or wet conditions under and
around the Cloud 9. Use caution! Surfaces around the product may become slippery
Cloud 9 QRG Rev. 5
QUICK REFERENCE GUIDE
EN
4