General Recommendations; Blade Care; Tools Required - Husqvarna 967322501 Manuel D'instructions

Tips For Improved Bagging
• Follow the mower operation instructions in the Operator
Manual.
• When using the grass catcher on a lawn where grass and
leaf bagging equipment has not been used previously,
thatch and debris that has accumulated for long periods of
time is picked up. The amount collected and the total time
of operation may be greater than will be experienced with
regular use of the grass catcher.
• Always run throttle at full speed when bagging.
• Select a ground speed low enough to give good mower
cutting performance, good quality cut and good bagging
performance.
NOTE: It may be necessary to overlap width of cut to suit
your conditions.
• If grass is extremely tall, it should be mowed twice. The fi rst
cut should be at one of the highest settings, the second time
to desired height.
• Use the left hand side of mower for trimming.
• Avoid cutting wet grass or in the morning while the dew is
still heavy. Grass clippings collected under these conditions
tend to be sticky and adhere to the walls of the fl ow path
causing clogging.
• If the grass catcher fails to pick up cut grass or leaves, it is
an indication that clogging has occurred in the system or
that the grass catcher containers are full.
a. Disengage blades, place motion control levers in neutral
position.
- Unlatch and raise cover.
- Slide out containers and dispose of clippings.
- Replace containers, close cover, and latch.
b. Unlatch chutes and check for clogging.
- Remove all debris in chute.
- Reassemble and latch chutes.

General Recommendations

Always observe safety rules when performing any maintenance.
• Before each use check for loose fasteners.
• Clean unit thoroughly after each use.

Blade Care

• For best results mower blades must be kept sharp.
Replace bent or damaged blades.
• See instructions in the mower operator manual.
Storage
When grass catcher is to be stored for a period of time, clean it
thoroughly, remove all dirt, grass, leaves, etc. Store in a clean,
dry place.

Tools Required

• Wrench 3/4" (2)
• Wrench 1/2" (1)
• Torque wrench (1)
• Drill with 7/16" bit
• Socket 1/2"
• Socket 9/16"
• Socket 3/4"
• Socket 15/16"
• Ratchet with 3/8" drive, 6" extension
• Wrench 1" (2)
• Wrench 9/16" (2)
• Screwdriver, standard (1)
NOTE: When right hand (RH) and left hand (LH) are mentioned
in this manual, it means when you are seated on the mower in
the operator's position.
4