Care And Maintenance - hylite ecoheater Manuel D'utilisation

INSTALLING THE ECO HEATER
IMPORTANT : THE HEATER SHOULD ONLY BE INSTALLED AND
OPERATED IN THE HORIZONTAL PLANE, USING THE MOUNTING
BRACKETS PROVIDED. IT SHOULD BE MOUNTED TO A WALL AT
LOW-LEVEL AND NOT BELOW A SOCKET OUTLET
Follow minimum clearances below and above the heater as shown
in [Fig.1]
Any shelving placed above the heater must be at a distance of at
least 200mm
The fixing brackets should be mounted according to the heater
length and at a distance to adequately support the heater
Once a suitable location has been found, screw the two bottom
halves of the bracket to the wall [Fig.2]
Place the Eco Heater on the brackets and then fasten top part of the
brackets over tube to secure.
DO NOT SWITCH ON THE HEATER UNTIL IT IS SECURED
ELECTRICAL
IMPORTANT: THE ELECTRICAL INSTALLATION OF THIS ECO HEATER MUST BE CARRIED OUT BY A
COMPETENT ELECTRICIAN, IN ACCORDANCE WITH THE CURRENT IEE REGULATIONS FOR ELECTRICAL
EQUIPMENT IN BUILDINGS
The Eco Heater is suitable for operation on a 50Hz AC supply voltage as shown on the identity label.
Before connecting the heater check that the supply voltage is the same as that stated on the identity label.
The input wiring, if connected to fixed wiring, must have a fused double pole switch in the power circuit.
After switching on the appliance for the first time the element will emit a vapour for approximately two
minutes. This is no cause for alarm, but is merely preservative burning out from the element.
The unit is fitted with a safety device, which will automatically cut off the heat source should the unit
overheat. The heater will re-energise once the temperature has reduced to the desired level.
NOTE: THIS APPLIANCE MUST BE EARTHED.

CARE AND MAINTENANCE

Wiping over with a damp cloth and finishing with a soft dry cloth can maintain the finish of your Hylite Eco
Heater
Cleaning should only be carried out when the tube heater is cold and switched off
DO NOT use abrasive cleaning powders or metal polish on any part of the tube.
English
200mm min.
Fig.1
30mm min.
Fig.2