Remote Control; Using The Remote Control; Inserting Batteries Into The Remote Control - Arcam Solo Neo Manuel

CR50 Remote control buttons
2
remote
Track/preset selection (0–9)
control
INFO
MODe
DISP
SLeeP
SLEEP
MeNu
Source selection
Cursor keys and OK
Mute
Volume – Use the
CD/uSB/NeT Media playback commands
CR50
(Power)
– Switches Solo Neo between stand-by and on.
– Press the number of the CD track or radio preset that you want to hear. To
select a track/preset greater than 9, press and hold the first digit of the track (e.g.
shown in the bottom left corner of the display ('1–'), then press the second digit.
– Changes the information shown on the front panel display.
– Some sources allow changes to the listening mode.
CD/USB/NET Media – Press the button to cycle through the repeat/shuffle modes for CD playback.
MODe
DAB/FM – Press to switch between 'tune' and 'preset' mode. When in tune mode, pressing
MODe
changes the tuned frequency (FM) or the selected station (DAB); in preset mode, the preset station is
C
changed.
NET Radio – Press the button to add or remove favourite stations.
MODe
– Cycles the brightness of the front-panel display. There are several different brightness levels to chose
from, including switching the display off.
– Activates the sleep timer function. The time until entering standby can be set in 5-minute steps.
– Pressing the button allows entry into the configuration menu of Solo Neo. This is described fully
MeNu
on pages 15—19. Press the button for a second time to leave the menu.
MeNu
– Press the appropriate button to select the audio source you would like to hear. The
button cycles through the external inputs ,
AV
– The cursor is used to choose items to play from USB and NET sources. These keys also
find use in navigating the configuration menus of Solo Neo, described on pages 15—19.
– Press once to mute the speaker and pre-amp outputs of Solo Neo. Press for a second time (or change the
volume) to unmute the unit.
- +
/ buttons to adjust the volume of the music.
4 (Play) – press this button to start the playback.
< (Stop) – press to stop playback.
(Pause) – press to pause playback . Press again (or press play) to re-start playback.
;
/ (Skip/Scan backwards) – press and release this button to skip backwards to the beginning of the current/
previous track. Press and hold the button to scan backwards.
0 (Skip/Scan forwards) – press and release this button of skip forwards to the beginning of the next track.
Press and hold the button to scan forwards.
(Open/Close) – press to open the CD tray; press again to close it.
1
) until the number is
1
, and .
TV GAMe FRONT
E14

using the remote control

Please keep in mind the following when using the

remote control:

Ensure that there are no obstacles between
<
the remote control and the remote sensor
on Solo Neo. The remote has a range of
about seven meters. (If the remote sensor
is obscured, the remote control input jack
on the rear panel is available. Please contact
your dealer for further information.)
Remote operation may become unreliable if
<
strong sunlight or fluorescent light is shining
B or
on the remote sensor of Solo Neo.
Replace the batteries when you notice a
<
reduction in the operating range of the
remote control.
Inserting batteries into the
remote control
eXT
1. Open the battery compartment by pressing the
button on the back of the remote control.
2. Insert two 'AAA' batteries into the battery
compartment, following the polarity indications
given inside the compartment itself.
3. Push the battery cover back into position.