Vonyx VMM-P500 Manuel D'instructions page 5

13. VU Meter (LED)
Displays the signal of output. The peak indicator lights up red when the output reaches the clipping level.
14. Headphone
3.5mm input jack for connecting a headphone.
15. Headphone Level
Use this control to adjust the output level of headphone.
16. Channel Faders
Adjusts the volume for corresponding channel. Use these faders to adjust the balance between the various channels.
17. Delay Control
Adjust the time interval of echo repeat.
18. FX Level
Adjust the effect volume.
19. Level Controller
Adjust to balance the volume of each channel.
20. USB Level Controller
Adjust the volume of the USB channel.
21. Master Fader
Adjust the output volume of the main mix.
22. USB Port
Connect your USB-device with this port. Please note: The USB port (27) on the rear panel of the device is solely for
power supply.
23. Play Button
Press the button to start/resume play or pause play. Long press to start recording.
24. Previous Button
Press the button shortly you can select the previous song, press long for decrease the volume.
25. Next Button
Press the button shortly you can select the next song, press long for increase the volume.
26. Mode Button
Press to switch modes.
27. USB Power Input 5V DC
USB socket for connecting the supplied power cord.
CONNECTING WITH BT
1.
2.
3.
If password is required, you can enter "0000".
Attention: The BT distance is approx. 10 meter without any barrier.
Activate the BT-function on your device (Mobile phone, tablet etc.) from which you want to play the
music. See the operating instructions for that device.
Press the "MODE" button and activate BT-function.
Select "VONYX-VMM" on your BT-device and make the BT-connection
5