Klein Tools ET500 Manuel D'instructions page 63

lIVe VIDeo MoDe
On startup, the borescope will enter the live output mode. The screen will
show the live output of the gooseneck camera along with the LED brightness,
date and time, and amount of video/photo storage remaining.
leD BrIGHtneSS
The borescope gooseneck camera head has several LEDs used to light your
work area. You can control the brightness using the "Bright+" and "Bright-"
buttons. The LED brightness ranges from off (LED:0) to full (LED:10). This
setting will be saved between uses.
Date anD tIMe
The date and time are shown in the upper right hand corner of the screen in
the format "Day/Month/Year Hour:Minute". The time is in 24 hour format. See
the TimeSet menu section.
StoraGe
The amount of storage in megabytes available in your current workspace is
shown on the bottom left. See Memory menu section.
takInG a pHoto
To take a photo, press and release the top trigger. The screen will momentarily
freeze to indicate a photo was taken. The date and time will be recorded onto
the image if the option is selected in the TimeSet menu.
recorDInG a VIDeo
To record a video, press and hold the bottom trigger for one second. The
video camera icon will begin to flash on the top left side of the screen to
indicate a video is being recorded. Press and hold the bottom trigger for one
second again to stop recording. All buttons will be disabled while recording
except for the power button which will still power off the unit and stop the
recording. DO NOT remove the SD card during recording.
rotatInG tHe caMera oUtpUt
Press the left or right button to rotate the camera output 180°.
7