Taurus Alpatec DH243 Mode D'emploi page 10

grams to set up the timer:
- If the timer setting is performed when the
appliance is in working status, it will switch off
after the desired time (1-24 hours). Press the
arrows to set the hours.
- If the timer setting is performed when the
appliance is off, it will switch on after the desired
time (1-24 hours). Press the arrows to set the
hours.
- The appliance will defrost automa-
tically as programmed once the sensor detects
temperature very low. Once defrosting finishes,
the appliance will recover to previous running
mode.
- If the water tank is full, the indicator
light comes on and flash.
- The ionization function can refresh the
air while killing viruses, dust mites, mould and
airborne allergens.
- Carbon filter: Take out the carbon filter from
bag and insert in on the filter. It is suggested to
change the carbon filter every 3 months.
-
- CONTINUOUS DRAINAGE OPERATION
- The appliance has a drainage port that allows
you to have continuous drainage.
- Connect a 10mm diameter pipe (not included in
the product) with the drainage port located on
back part of the unit.
- Ensure the hose is directed downwards,
allowing water to flow to an external drain.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off, using the on/off switch
(i).
- Unplug the appliance from the mains.
- Remove the water from the water tank.
- Clean the appliance.
CARRY HANDLE/S:
- This appliance has a handle on the upper part
of the body, which facilitates comfortable trans-
portation (B).
SAFETY THERMAL PROTECTOR:
- The appliance has a safety device, which pro-
tects the appliance from overheating.
- If the appliance turns itself off and does not
switch itself on again, disconnect it from the
mains supply, and wait for approximately 15
minutes before reconnecting. If the machine
does not start again seek authorised technical
assistance.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- Dry all parts before its assembly and storage.
CLEANING THE AIR FILTER:
- When used regularly, the filter may become
clogged with dust and particles. Therefore, the
filter should be cleaned every one or two weeks.
- Remove the filter by pulling it out carefully.
- Clean the filter with a vacuum cleaner or with
water.
- Let it dry completely and re-install it on your
device. Do not wash the filter in the dishwasher.
ANOMALIES AND REPAIR
- Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
- If any anomaly is detected, check the following
table: