Belkin TuneStage Mode D'emploi page 6

Operating Instructions
STEP 3: TuneStage 2 Setup for Use with Headphones Enabled with
Bluetooth Technology (Optional)
NOTE: TuneStage 2 will only pair with stereo headphones enabled with Bluetooth technology
that have a pairing code of 0000. Consult your headphones' manual for the pairing code.
1. Make sure the TuneStage 2 Receiver's power button is in the off position.
2. Put your headphones enabled with Bluetooth technology into pairing mode. Consult your
headphones' user manual on how this is done.
3. For best results, the Transmitter should be close to the headphones when first making a wireless
connection.
4. Power on your iPod, and then insert the TuneStage 2 Transmitter into the bottom of
the iPod.
5. The Transmitter will power on automatically, and the blue LED will begin to blink rapidly while it
searches for your headphones to which to pair.
6. Your headphones' LED indicator should also blink during pairing. Consult your headphones'
user manual on how the LED-indicator light works.
7. The TuneStage 2 Transmitter and your headphones should pair within 60 seconds. You will be
able to hear music through your headphones if your iPod is in play mode.
8. You can now play any song on your iPod through your headphones. You can control the volume
and track change features through your iPod or through the headphones if they feature these
controls. NOTE: Volume control through the click wheel is supported only on the iPod 5th
generation (video), iPod nano 1st generation, and iPod nano 2nd generation (aluminum).
Operating Instructions | 06