Publicité
Les langues disponibles
Les langues disponibles
EN: Mounting ESM knife bar
G90900102
Dokument: G90950115
Attention:
Danger of injury from the sharp
knife blades!!!
Wear cut-resistant gloves when
working on it!
.
Scope of delivery of the two
packages of the ESM cutter-bar.
-
Beam with cutter bars
-
Centre drive
-
Claw adapter
-
2 sliding shoes with screws
-
4 cylinder head screws
M12x1,5x20
-
2 bolts M12x60 with washers
and nuts
Seite 7
First remove the two cutter bars.
To do this, lift the upper knife guide
arms with a screwdriver. Remove
the plastic blade guard before.
The driving pin of the cutter bar is
free. Pull out the upper knife tilted
forwards. Do not leave the upper
guide arms in the upright position
for a longer period of time!
Lever the lower blade out of the
driving pins with a screwdriver and
remove it upwards.
www.as-motor.de
Publicité
