Cleaning/Replacing The Air Filter; Maintaining The Spark Plug; Changing The Engine Oil; Checking/Sharpening/Replacing The Blade - Deltafox DG-PLM 4219 SP Traduction De La Notice D'utilisation Originale

GB
Cleaning/Replacing the
Air Filter
Do not operate the equipment
without the air filter otherwise dust
and dirt will get into the engine and
result in damage to the machine.
1. Remove the spark plugs connector (
11) (see "Maintaining the Spark
Plug").
2. Open the air filter box (9) and take out
the air filter (10).
3. Clean the air filter (10) with soap solu-
tion and let it dry. Put a few drops of
fresh engine oil into the air filter.
4. To install, place the air filter (10) in the
air filter box (9) and reclose it.
5. For assembly, place the air filter (10)
into the air filter box (9) and close it
again.
Maintaining the
Spark Plug
A worn spark plug or a spark gap
that is too large will result in a re-
duction of engine performance.
1. Disconnect the spark plug connector
(11) from the spark plug (12) by simul-
taneously pulling and turning.
2. Unscrew the spark plug (12) anti-
clockwise.
3. Check the spark gap using a feeler
gauge (available from specialist
shops). The spark gap must be at
least 0.5-0.6 mm.
4. If necessary, adjust the gap by care-
fully bending the ground electrode on
the spark plug.
5. Clean the spark plug with a wire brush.
6. Insert the cleaned and adjusted spark
plug or replace a damaged spark plug
90
with a new one (recommended torque
20 Nm, determined with a torque
wrench) (see "Replacement parts/Ac-
cessories").

Changing the Engine Oil

Change the engine oil with the petrol
tank empty and the engine warm.
• Change the engine oil for the
first time after around 5 operat-
ing hours then every 50 operat-
ing hours or annually.
• Dispose of the used oil in an
ecofriendly manner (see "Dis-
posal/Environmental protection").
1. Remove the spark plug connector
( 11) (see "Maintaining the Spark
Plug").
2. Open the oil tank cover (
pump out the motor oil with an oil pump.
3. Refill with engine oil (see "Initial Op-
eration").
Checking/Sharpening/
Replacing the Blade
Only allow specialist companies to
sharpen the blade.
Wear gloves when handling the
blade.
Never tilt the lawnmower to the
side or forwards when the petrol
or oil tank is filled!
This could damage the engine,
voiding the warranty.
• Take off the spark plug connector
( 11) and check the blade for wear
and damage.
19) and