Troubleshooting - Gyration GO Guide De L'utilisateur

GC1005M_NA_IB_REVA_K6.qxd 2/11/05

Troubleshooting

Symptom Reason
Mouse LED comes on when activate Mouse and Receiver not
button is pressed, but receiver is synchronized
unresponsive
When using in air, cursor is visible but Gyroscope not activated
shows no movement
Cursor movement is choppy or erratic Radio interference
When pressing the Activate button, the Batteries are low
LED on the mouse is flashing
When pressing the Activation Trigger, Batteries are dead
the LED on the mouse is off
Mouse is off
Cursor moves too fast or too slow Speed or acceleration not
set properly
Cursor drifts on the screen Sensor may require
recalibration
Mouse LED does not flash in charging Dirty contacts
cradle and mouse does not charge
End-of-life battery
Inadequate battery life Mouse used on dark-colored
surface
11:33 AM Page 12
Solution
Perform a Connect/Connect sequence (see
Setting Up and Synchronizing the G.O. Air Mouse
and the Gyration RF Receiver on page 4).
Squeeze or double-click trigger on bottom of
mouse.
Move receiver away from other electronic devices
(i.e., monitor, speakers, radio, etc.).
Recharge battery pack or replace (see Installing
and Charging the Batteries on page 1).
Recharge battery pack or replace (see Installing
and Charging the Batteries on page 1).
Power it on (see Powering the G.O. Air Mouse On
and Off on page 5).
Change the cursor tracking speed in the mouse
control panel.
Place the mouse on the desk for 4 or more
seconds to steady the cursor.
Clean the contacts on bottom of mouse.
Replace battery
Use mouse on light-colored surface to minimize
battery drain.
12