Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Super-Vee™
TO CHANGE CABLE CARTRIDGES
DISCONNECT MACHINE FROM POWER SOURCE
BEFORE INSTALLING CABLES OR CARTRIDGES!
1.
Remove the cutter and connecting screw from the cable, if one is
attached.
2.
Loosen three screws that hold
front and back of container
together.
3.
Pull the container front off of
the machine, revealing the
cable cartridge within.
4.
Remove the cable cartridge.
5.
Press replacement cartridge firmly into back of container. Make
sure to line up the grooves in the cartridge with the slots in the
container back.
6.
Slide the cable through the container front.
7.
Position the container front so that the three screws aligned with
the slots in the container back. Press the container front into the
container back.
8.
Tighten screws firmly, making sure the screw heads are centered
in the slots and flush with the container surface.
MAINTENANCE
DISCONNECT MACHINE FROM POWER SOURCE
BEFORE PERFORMING MAINTENANCE!
To keep your machine operating smoothly, it is essential that all bear-
ings and bushings be lubricated. Oiling moving parts is particularly
important where machine comes in contact with sand, grit and other
abrasive material.
TROUBLE SHOOTING GUIDE (TABLE 3)
Problem
Cable kinks or breaks.
Cable tangles in container.
Motor does not run.
Motor turns in one direction
but not other.
Probable Cause
Operator forcing the cable.
Too much slack between machine and drain. Do not allow more than six inches between machine and drain.
Cable used in wrong size drain line.
Cable exposed to acid
Operator forcing the cable.
Trigger in neutral (off) position.
Reverse switch failure.
CABLE MAINTENENCE
To get maximum service from your cables, be sure
that they are clean and well oiled. This not only pro-
vides running lubrication but greatly extends the life
of the cables as well. Some users periodically pour
oil directly into the drum. Then, as the drum turns,
the cables get complete lubrication. Our SNAKE OIL
is ideally suited for this purpose, since it not only
lubricates the cables, it deodorizes them as well.
TO CLEAN OR REPLACE GRIPPERS
If your Super-Vee is not gripping the cable properly, the cable grippers
may need to be cleaned or replaced.
1.
Loosen the 3/8" set screws and the slotted screw in the front
collar.
2.
Remove the front collar and slide off the grip shield.
3.
Remove screws holding the cable grippers.
4.
Clean or replace cable grippers.
5.
Re-grease grippers and reassemble.
TO REMOVE MOTOR
1.
Loosen the three screws that hold the container front and back
together.
2.
Pull the container front off of the machine.
3.
Loosen the two set screws in the beveled collar and remove both
the collar and the felt washer.
4.
Slide a flat head screw driver into the Hub Spindle and unscrew
the Left Hand locking screw from the drive shaft by turning it
clockwise.
5.
Unscrew the Hub Spindle from the Right Hand Drive Shaft by
rotating the container back counter-clockwise. Note: The Hub
Spindle, Hub, and Container Back remain as one unit. The thrust
bearing will spin freely.
6.
Reverse these instructions to re-assemble.
Solution
Do not force the cable. Let the cutter do the work.
A cable that is too large or too small in diameter for a line is more
likely to kink. (Consult Table 1—Cable Applications.)
Clean and oil cables regularly.
Do not force the cable. Let the cutter do the work.
Switch Trigger to either Forward or Reverse.
Replace reverse switch.
6
Publicité
Table des Matières
