Usage; General Information; The Positions For The Dust Extractor - Husqvarna HTC D80 Manuel De L'opérateur

Usage

4 Usage
4.1

General Information

The following section describes the different positions for the dust extractor and how to
change the Longopac. The section also deals with the operation of the dust extractor.
Warning!
The dust extractor may only be used or repaired by personnel who have
received the requisite theoretical and practical training and who have read the
user manual.
Warning!
Use protective equipment such as safety shoes, safety goggles, protective
gloves, breathing mask and hearing protection.
Warning!
The dust extractor may only be used and moved on level surfaces. There is a
risk for crush injuries, if it should start to roll.
Tip!
Check the minimum recommended cable area before using an extension cord.
You will find the recommended cable area under Technical data, page 50.
4.2

The positions for the dust extractor

The dust extractor can be placed in two positions; transport position and service position
(replacement of sock filter), see Figure 4-1,
Warning!
If handled carelessly, the dust extractor can overturn and cause both personal
injury and damage to the equipment.
Note!
The HEPA filter holder must be removed before the dust extractor can be
lowered to the service position, since the hose between the upper cylinder
section and the HEPA filter holder will otherwise make this impossible.
14
page 15 and Figure 4-2, page 16.
HTC D80
1.1