Warn 80335 Instructions De Montage page 6

INSTALLATION CONT.
8. Remove the cover that is located on the front
bumper, the cover is attached with 4 torx
head screws. Place the bumper back into
position and check for fit. Because of the
variation in each vehicle make sure that the
roller fairlead will fit into the opening of the
front bumper.
9. If the the roller fairlead contacts the front
bumper, spacing the fairlead out with a
washer between the fairlead and the bracket
or cutting away part of the plastic bumper
should alleviate the fit issue, see figure 7 and
8
10. Attach the roller fairlead to the fairlead
bracket, use the hardware that came with the
winch.
11. Replace the bumper and tighten down all
fasteners.
WARNING
READ THE VEHICLE'S OPERATOR MANUAL,
WINCH OPERATOR MANUAL, AND ALL WARN-
ING LABELS PRIOR TO OPERATION OF ATV
AND WINCH.
THE WINCH MOUNTING PLATE INSTALLATION IS NOW COMPLETE.
• Wire winch according to instructions found in winch kit.
PROCEED TO SECTION TITLED "MAINTENANCE/CARE".
WARN INDUSTRIES PAGE 6
Figure 7
Figure 8
80343A0