Warn 80335 Instructions De Montage page 4

VI. INSTALLATION
1. Remove front bumper assembly, make sure to
disconnect the head lamps before removing
the bumper. The bumper is attached with 6
torx head screws and 4 plastic push tabs
attaching the bumper to the front fenders.
2. After removing the front bumper place the
mounting plate into position see figure 2. At
this time also place the winch into position
along with the mounting plate.
3. Before attaching the mounting plate to the
frame the winch will have to be attached to
the mounting plate. Once the winch has been
attached to the mounting plate tighten down
all four bolts to the recomended torque of 17
lb. ft.
4. Attach the mounting plate with the winch to
the frame using 2 1/4-20 U-bolts, washers
and locking hex nuts. Just finger tighten the
hex nuts at this time. This will help hold the
mounting plate into position while attaching
the fairlead bracket and the rest of the hard-
ware, see figure 3.
WARN INDUSTRIES
Front bumper assembly
PAGE 4
Figure 1
Figure 2
Figure 3
80343A0