Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
M1.1.RV4000.NLFREN 15062018
EN
4 Operation
•
Place the device on a flat and stable surface.
•
Connect the blowing pipe to the outlet with a "hook & loop" belt, an elastic line with hooks at the end or another
suitable material. Press the material and make sure that the blowing pipe is correctly and safely connected to the
blown object.
•
Connect the device to an earthed socket.
•
Set the desired speed of the fan:
- It is recommended to use high speed during blowing and low speed during normal operation. As a result, the
pressure inside the object will not exceed the permitted value.
- In order to dry floor, it is recommended to use the medium blowing speed.
•
Set the switch to ON.
•
Check for correct operation, before the unit is left unsupervised.
•
Do not move or carry the fan during operation.
5 Maintenance
WARNING!
Always pull out the mains plug before maintenance and repair work.
Inspection of the electrical system
Check the electricity cable regularly for damages. Remove the housing regularly and check the internal wiring for blank
conductors, loose fittings and discolouration. Take out and repair damaged cables if necessary.
Clean air inlets
Fluff and other dirt that has collected at the air inlet must be removed. Remove fluff, lint and dust from the fan wheel,
motor and side covers with a vacuum or compressed air.
Clean housing
Clean the housing with a mild detergent and water. Restore the original shine with vinyl cleaner and polish, e.g. used for
synthetic materials for vehicles.
External checking
Check the external parts and make sure that they have been properly installed. Look out for unusual noises.
Engine and wiring must remain dry
The ventilator cannot be cleaned with a water hose or pressurised washing device to prevent electrical components from
getting damaged. If electrical components still get wet, they must be dried immediately.
9
Publicité
Table des Matières
