5.1.4
Cross sensitivity
Sensors for gas detection may respond to other gaseous substances in
the ambient air (such as cleaning agents or solvents) in addition to the
gases to be detected.
Verify that no substances are used in the detection area of the product
which outgas solvents or other chemicals.
- Such substances can trigger an alarm.
5.2
Mounting the product
Verify compliance with the technical specifications and all specifications
concerning mounting.
1. Mount the housing to the wall using screws.
- Holes for mounting are provided at the rear of the housing.
5.3
Electrical connection
ELECTRIC SHOCK
•
Verify that the degree of protection against electric shock (protection class,
double insulation) is not reduced by the type of electrical installation.
Failure to follow these instructions will result in death or serious injury.
ELECTRIC SHOCK CAUSED BY LIVE PARTS
•
Disconnect the mains voltage supply before performing the work and ensure
that it cannot be switched on.
•
Verify that no hazards can be caused by electrically conductive objects or
media.
Failure to follow these instructions will result in death or serious injury.
Mounting
DANGER
DANGER
GS 1.1./GS 2.1/GS 4.1
EN
15