OHAUS 71208792 Manuel D'instructions page 6

EN-4
Cone Cover (for small-frame models)
Figure 2A.
Figure 2C.
3. INSTALLATION OF SOFTWARE
After installing the hardware, install the USB driver software contained in the kit CD.
3.1 Software Installation
1. Insert the supplied CD into the CD-ROM drive of the computer.
2. Connect the balance to the computer's USB port through the USB cable
(supplied).
3. "Found New Hardware Wizard" window will come up. The following screen shots
are examples of the installation using Windows 2000
operating systems may show a similar window with a slightly different look.
"Hardware Wizard" in all versions of Windows
installation of the necessary 2 drivers located on the CD with steps described
below.
USB PCB
COM2 Cover Plate
Figure 2B.
Figure 2D.
®
. Other Mircrosoft Windows
®
will guide you through the
USB Interface Kit
PCB Cable
®