Jacob Delafon CARAFE Notice Technique page 4

156
81
318
245
150
0 - 50
375
196
G3/8"
G3/8"
Cartridge
upper view
74.5
Cartridge
upper view
32
Ø81 Ø12.5
77.5
38
295
44
60 Ø3/8"
38
70.5
E18865-..
TEMPERATURE SETTING
A temperature-control ring (A) attached to the valve will
control leftward lever movement and thus adjust the
temperature of hot and cold water. (according to ÀÁÂÃÄ)
Â
Á
À
A
Ä
IMPORTANT ADVICES IN THE INSTALLATION
• Drain pipes thoroughly before installing.
• At first, open the mixed water handle to remove all
the last deposits to preserve the filter.
• At the first use of filtered water, it is advised to drain
the feed-water system and the filter with a strong flow
of water
by turning the handle to the maximum until the water is clear.
• Have static water pressure of at least 1 bar, 3 bar advised, 6
bar maximum, beyond that, we advise you to install a pressure
reducing control valve.
WATER SUPPLIES CONNECTION
Ù
Filtered
Flow regu-
water
lator
filtered water
Red :
supply
hot water supply
Drain to
channel
Blue :
REPLACING THE MIXER VALVE
1. Turn off the water supplies.
2. Remove the cap.
3. Loosen the handle screw.
4. Lift the handle.
5. Loosen the cup.
6. Loosen the nut.
Ã
7. Lift the valve.
8. Install the new valve.
9. Block the nut
(torque 11N.m).
10. Screw the cup.
11. Reinstall the handle,
tighten the screw.
12. Fit the cap.
13. Turn on the water supplies, verify the working.
• Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain cysts.
• Before each use of filtered water, drain the pipes and the filter allowing water to flow for 5 seconds.
• The cartridge must be changed every 6 months of use. In case of intensive use (over 40 l/day), the replacement
will be done after 7500l of consumption.
• The filtered water temperature must be between 5°C (40°F) and 35°C (100°F).
• Allow minimum of 2'' (5cm) clearance under filter to facilitate cartridge change.
• The cartridge must be installed apart from heat and direct sunlight.
You can replace the cartridge without shutting off the water.
<
Filter holder with a system of automatic water cut-off from the
disassembly of the cartridge
reference
mark
Mixed water
À
!
Warning
tastes and odours transmitted by drinking water. JACOB DELAFON can not be held liable for any effects caused by
the failure to comply with instructions for use and maintenance or improper use of this product.
REPLACING THE 1/4 VALVE
(FILTERED WATER)
1. Turn off the water supplies.
cold water supply
2. Loosen the handle screw and remove the handle.
3. Loosen the valve screw.
4. Remove the spline adapter, the adapter and the protector.
5.Loosen the vlave with an tubular socket wrench of 15.
6.Tighten the new head (torque 10N.m).
7. Reassemble the protector, the adapter and the spline adapter.
8. Tighten the handle screw.
9. Reassemble the handler, tighten the screw.
10. Open the water supplies, verify the operation.
Handle
Screw
Cap
Cup
Nut
Valve
MAINTENANCE :
with a non-abrasive sponge and soap, rinse thoroughly and dry with a soft cloth. Do not use harsh products containing
methyl alcohol, acids, solvents or abrasives that can damage the finish.
INSTALLATION AND FILTERED WATER USE ADVICES
REPLACING THE FILTRATION CARTRIDGE R8A360NF
drain pipe
Expect the flow of
a small amount of
water
Á Â
DISMANTLING
• This product is not a system for water treatment, but a filter for the reduction of
Screw
Handle
Screw
Spline Adapter
Adapter
Protector
Head
This mixer has a finish which requires special care. To maintain its shine and luster, clean regularly
rotation
about 90°
À Á
REASSEMBLING
REPLACING THE SPOUT
Align
holes