Albrecht BPA 400 Manuel page 12

2. Charging
Before the first use, please recharge the device fully until the red
light of the function button turns off.
Low power notification
When the power becomes lower than 10%, the function button
will flash red and a voice message will announce power lower
than 10%. Please recharge immediately.
3. Turn On/Off
Turn on: long press function button for 3 seconds until the voice
announcement „Power On" and the function button starts flas-
hing blue.
Turn off: When the device is on, long press function button for
3 seconds until the voice announcement „Power Off" and light
stops flashing.
4. Bluetooth Pairing/Connection
Always connect at least one device via Bluetooth to the BPA 400.
Otherwise the unit will automatically switch to stand-by after 5
minutes to save the battery.
1. When the device is off, long press function for 5 seconds until
red and blue light flashes and you hear a „Beep" tone.
2. Switch on Bluetooth at your cellphone, search for „Albrecht
BPA 400" and press connect. When the red and blue light chan-
ges to blue, a „Beep" sound is heard and pairing is complete.
3. The BPA 400 will connect automatically to the last paired unit
if you turn it on the next time.
4.1. Second connection with GPS/cellphone
In the first step pair and connect the first Bluetooth device, then
turn off the BPA 400. Now pair and connect the second Bluetooth
12