Rf Installation With Control Conductor Receiver - RADSON 4 Zones RF Clock Guide D'utilisation

2.3.2 RF Installation with Control conductor
receiver
a) First of all you must put all Control conductor receivers
which need to works on the same zone in "RF init"
mode.
For this, press the Receiver push button during 5sec, the
Green RF LED should lit up (fixed) indicating that the
Receiver is now in radio configuration mode waiting for a
clock configuration address.
5s
b) Now on the clock, you must enter in the installer menu
by pressing the (
screen must be display.
) key during 8s, then the following
11
...